Optimal Operation of Soil Aquifer Treatment System
Mathematical models based on nonlinear programming are developed for operating soil aquifer treatment(SAT) systems. The objective of these optimization models is to determine the operation...
Wet Detention Facility Pollutant Removal Modeling
This paper documents development of the WETPOND model, which simulates long-term pollutant removal by a wet detention facility. Pollutant removal is determined with an EPA procedure that...
The Sensitized Photocatalysis of a Mixed Reactant System of 4-Chlorophenol and 4-Nitrophenol
Sensitized photocatalysis has been demonstrated with colored pollutants such as nitrophenols. With visible light excitation of an adsorbed nitrophenolic compound, charge injection into...
Experimental Design and Measurement Techniques for Investigation of Two-Phase Flow
Discussing the relevant hydraulical and inter-phasial processes of two-phase flow in open tanks the necessary requirements for set-up and operation of physical model studies are worked...
Innovative Instrumentation for a Physical Model of River Ice Transport
Large physical models often require the use of innovative instrumentation and measurement techniques. Hydraulic models that attempt to simulate the effects of stationary ice covers put...
Acoustic-Doppler Velocimeter (ADV) for Laboratory Use
A remote-sensing, three-dimensional (3D) velocity sensor has been developed and tested for use in physical model facilities. The sensor is based on the Acoustic Doppler principle and measures...
Revised Hydraulic Design of the Rio Hondo Flood Control Channel
The US Army Engineer District, Los Angeles has completed a major review study of the Los Angeles County Drainage Area (US Army, 1992) and has determined that the existing flood control...
Use of a Modified Hybrid Model to Analyze the Effectiveness of Jetties in Reducing Marina Sedimentation
The effectiveness of the construction of jetties near the entrance channel of a coastal marina in reducing marina sedimentation has been analyzed using a modified hybrid model. The modified...
PSF-PM Verification of 3D Free Surface Flow Models
This paper reports an application of the Prescribed Solution Forcing (PSF) and Physical Modeling (PM) to the development of a systematic procedure for the verification of three-dimensional...
3D Free Surface Flow Model Verification - A Panel Discussion on Test Cases
This paper is to briefly present the objectives and approaches of the Panel Discussion on test cases to be developed for 3d free surface flow model verifications, so that professionals...
Modeling Kinetics of Sediment Removal in Water Columns
Many physical, chemical, and environmental factors govern the rate of cohesive particle sedimentation in aquatic environments. A new information-based model that uses experimental information...
Predicting Turbine-Generator Foundation Vibrations
Two of the major considerations in the design of large turbine-generator foundations are to maintain the proper shaft alignment and to limit the vibration of the machine during operation....
Neural Networks in Structural Control
Let the response of a simple two-story frame to a stochastic dynamic excitation be controlled by activating suitable actuators. A neural network is trained to recognize, from the measurement...
Bonded Polyester Concrete Overlays Used in California
Bonded polyester concrete overlays have been very successful in California in restoring and preserving bridge decks from damage by road salts. The polyester concrete system has been employed...
A Note on Physical Modeling Approach for Assessment of Excavation Techniques
With the growing interest in utilizing underground space, the need for quantitative and qualitative assessment of excavation techniques to dictate the best choice for mining is now becoming...
Scale Dependence of Effective Media Properties
For problems where media properties are measured at one scale and applied at another, scaling laws or models must be used in order to define effective properties at the scale of interest....
Simulated Hanford Waste: A Study of Physical Properties, Gas Retention, and Gas Generation
This study helps to establish the physical and chemical processes responsible for the generation and retention of gases within high-level waste contained in Tank 101-SY on the Hanford...
Thermal-Hydraulic Analyses of Molten Glass in a Joule-Heated Melter
Physical modelling using glycerine and three-dimensional mathematical modelling were executed to study temperature and flow profiles of molten glass in the melter for the vitrification...
Subsidence Properties of Holocene Sediments: S. La.
As part of a comprehensive USGS-sponsored study of processes that drive subsidence and wetland loss in south Louisiana, two continuously cored deep borings (60 m and 72 m) were acquired...
Physical Modeling of Barbers Point Harbor
Physical modeling is a practical tool in the design of coastal projects. A physical model of Barbers Point Harbor located on the island of Oahu, Hawaii was constructed so that different...
Return to search